Products > Test Equipment
New Rigol DS1054Z oscilloscope
bastech:
--- Quote from: tv84 on March 30, 2021, 03:30:55 pm ---:( Love that msg. Let me have another look.
Try this one.
--- End quote ---
Same. "Update was failured" I used two 8GB pendrives and nothing.
I also sent an e-mail to Rigol Support but have not been responsible for several days.
Echh it's through my hurry, better slower but more precisely ...
ebastler:
Is this the same problem as discussed here?
https://www.eevblog.com/forum/repair/error-updating-rigol-ds1054z/
Reply #7 in that thread describes a solution which worked back then. But that may be what tv84 has prepared aready?
tv84:
--- Quote from: ebastler on March 30, 2021, 05:21:09 pm ---Is this the same problem as discussed here?
https://www.eevblog.com/forum/repair/error-updating-rigol-ds1054z/
--- End quote ---
:-+ I knew this was already discussed but I didn't find it.
I think the solution then was something like this file attached. Flash it over a DS1kZ with wrong DS1kZ-E FW.
bastech:
--- Quote from: tv84 on March 30, 2021, 05:41:50 pm ---I think the solution then was something like this file attached. Flash it over a DS1kZ with wrong DS1kZ-E FW.
--- End quote ---
Again the same error.
I think it's a waste of time for that.
Thank you tv84 for your help. Maybe in the future someone will find a solution. And now ... the two channels are worse than four but better than nothing ;-)
tv84:
--- Quote from: bastech on March 30, 2021, 07:18:17 pm ---Again the same error.
I think it's a waste of time for that.
Thank you tv84 for your help. Maybe in the future someone will find a solution. And now ... the two channels are worse than four but better than nothing ;-)
--- End quote ---
We are missing a step. According to sebastos08's msg in that thread, BEFORE YOU DO ANYTHING, you have to flash the 00.06.02.00.01 (here).
I think only after that you can flash my previous file.
Try and report.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version