Products > Test Equipment
New Rigol DS1054Z oscilloscope
Adrian_Arg.:
--- Quote from: PeDre on October 15, 2021, 07:36:25 pm ---
--- Quote from: Adrian_Arg. on October 14, 2021, 03:16:48 pm ---Bicurico, did you test if the synchronization problem was corrected with captures at 24 megabits?
--- End quote ---
Hello Adrian,
the error still exists.
Peter
--- End quote ---
Thanks PeDre, it seems that it is an error without solution, since they have released several firmware and they have not solved it :-\
rob040:
--- Quote from: Adrian_Arg. on October 16, 2021, 06:25:01 pm ---Thanks PeDre, it seems that it is an error without solution, since they have released several firmware and they have not solved it :-\
--- End quote ---
Is Rigol aware of this error? I'm asking because when I confronted the EU service rep years ago with the lack of solving the pulses/pluses error, he answered "We just heard of it" while it was already an issue on this forum for a long time. Several months later it was fixed...
Adrian_Arg.:
--- Quote from: rob040 on October 16, 2021, 07:57:47 pm ---
--- Quote from: Adrian_Arg. on October 16, 2021, 06:25:01 pm ---Thanks PeDre, it seems that it is an error without solution, since they have released several firmware and they have not solved it :-\
--- End quote ---
Is Rigol aware of this error? I'm asking because when I confronted the EU service rep years ago with the lack of solving the pulses/pluses error, he answered "We just heard of it" while it was already an issue on this forum for a long time. Several months later it was fixed...
--- End quote ---
I at the time sent the link where the error and own captures are discussed and he will answer that it was solved and it was not.
Adrian_Arg.:
Friend RoGeorge how to use this file * Rigol_sign_disk.zip, which you posted. slds
RoGeorge:
The instructions of how to use it are in the same place where Rigol_sign_disk.zip is attached, https://www.eevblog.com/forum/testgear/new-rigol-ds1054z-oscilloscope/msg3613778/#msg3613778
First, you extract the content from the zip. You will get a file named "card_FAT32_w_SIGN_manually_added_103E00". Then, you use either dd (in Linux) or Win32DiskImager (in Windows), as Miti tested in the next reply after the one linked. Once you prepared the disk, you copy any firmware you want and then do the update procedure.
1. Why do you need the disk?
2. What exactly is not working on your oscilloscope?
3. What did you tried so far and what are the results?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version