Products > Test Equipment
New Rigol DS1054Z oscilloscope
Electrofinn:
Can anyone please tell me if this weird knot is normal? only seems to happen on channel 1. Also included picture with all four channels enabled.
ataradov:
Yes, this is normal. you are triggering on channel 1, so all the rising edges get shown on top of each other. If you switch to any other channel and switch the trigger source to the same channel, you will see the same exact thing.
Electrofinn:
--- Quote ---Yes, this is normal. you are triggering on channel 1, so all the rising edges get shown on top of each other. If you switch to any other channel and switch the trigger source to the same channel, you will see the same exact thing.
--- End quote ---
Ahh yes I see, just done that and yes it does exactly as you described. I'm Just a beginner with much to learn, thank you. :-+
trmntr:
Good evening! Is there any reliable information about what these values ​​highlighted in the attached photo mean? Each time reload, these values, underlined in red, change each time.
RoGeorge:
The last one, 11, tells how many time you powered on the oscilloscope. If you turn it off, then on again, it should show 12.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version