Products > Test Equipment
New Rigol DS1054Z oscilloscope
<< < (964/966) > >>
Adrian_Arg.:
Since I installed the latest firmware on the DS1054Z, it does not allow me to calibrate, I almost reached the end of the progress bar, and the function exits.
MarkF:

--- Quote from: Adrian_Arg. on September 20, 2024, 04:46:31 pm ---Since I installed the latest firmware on the DS1054Z, it does not allow me to calibrate, I almost reached the end of the progress bar, and the function exits.

--- End quote ---

The latest version of firmware for the DS1000Z is 00.04.05.02.08.
It can be downloaded here:  DS1000Z & Z-Plus  00.04.05.02.xx

For calibration to complete, you need to allow the scope to warm-up for at least 30 minutes and remove all the probes.
Karel:
It happened also to me that, after the fw update, when I did the calibration (no probes attached,
more than 30 minutes warmup etc.), it got stuck.
After waiting for another hour, I switched it off, and switched it on again.
Then I did the calibration again and it succeeded without problems...  :-//

Chinese software I guess...  :-DD
Adrian_Arg.:
If that is the version I have installed, it does not let me calibrate and I could not find any information about what they improved.
Fungus:

--- Quote from: Adrian_Arg. on September 20, 2024, 08:56:44 pm ---If that is the version I have installed, it does not let me calibrate

--- End quote ---

Did you just "upgrade"? Did it work before?


--- Quote from: Adrian_Arg. on September 20, 2024, 08:56:44 pm ---and I could not find any information about what they improved.

--- End quote ---

So why install it?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod