Products > Test Equipment
New Rigol DS1054Z oscilloscope
Adrian_Arg.:
Since I installed the latest firmware on the DS1054Z, it does not allow me to calibrate, I almost reached the end of the progress bar, and the function exits.
MarkF:
--- Quote from: Adrian_Arg. on September 20, 2024, 04:46:31 pm ---Since I installed the latest firmware on the DS1054Z, it does not allow me to calibrate, I almost reached the end of the progress bar, and the function exits.
--- End quote ---
The latest version of firmware for the DS1000Z is 00.04.05.02.08.
It can be downloaded here: DS1000Z & Z-Plus 00.04.05.02.xx
For calibration to complete, you need to allow the scope to warm-up for at least 30 minutes and remove all the probes.
Karel:
It happened also to me that, after the fw update, when I did the calibration (no probes attached,
more than 30 minutes warmup etc.), it got stuck.
After waiting for another hour, I switched it off, and switched it on again.
Then I did the calibration again and it succeeded without problems... :-//
Chinese software I guess... :-DD
Adrian_Arg.:
If that is the version I have installed, it does not let me calibrate and I could not find any information about what they improved.
Fungus:
--- Quote from: Adrian_Arg. on September 20, 2024, 08:56:44 pm ---If that is the version I have installed, it does not let me calibrate
--- End quote ---
Did you just "upgrade"? Did it work before?
--- Quote from: Adrian_Arg. on September 20, 2024, 08:56:44 pm ---and I could not find any information about what they improved.
--- End quote ---
So why install it?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version