Products > Test Equipment
New Rigol DS7000
<< < (37/72) > >>
wat:
I've used it a bit, generating some waveforms with a microcontroller (dacs and PWM output, ignore the not-perfect saw-tooth, it's normal like this).

The response is good, just one critic: it should save the settings when powering off: after boot it always starts up with the default settings: all 4 channels active, 1V/div and 1us/div. Digital inputs off.

Probably every other DSO at power up has the settings that were left last time it was used :(
TurboTom:

--- Quote from: wat on October 01, 2018, 09:29:04 pm ---...
Probably every other DSO at power up has the settings that were left last time it was used :(

--- End quote ---

Have a look at the manual, page 19-6, "Power On". Configure this setting to "last" it should work as you are used to.
Fungus:

--- Quote from: wat on October 01, 2018, 09:29:04 pm ---Probably every other DSO at power up has the settings that were left last time it was used :(

--- End quote ---

Even the humble DS1054Z has a menu item to select that... :popcorn:
2N3055:
Press Utility  System, and then press Power On continuously to select "Last" or
"Default". By default, it is "Last".
 Last: returns to the setting of the system at last power-off.
 Default: returns to the factory setting of the system.

manual is your friend.....
wat:
Thank you guys ( :palm: ) 

Honestly I wasn't expecting it could exist an option different from "Last", I've never seen it before on any scope (or maybe I forgot about it...)
I'll read the manual, promise!

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod