Products > Test Equipment

New Rigol DS7000

<< < (37/72) > >>

wat:
I've used it a bit, generating some waveforms with a microcontroller (dacs and PWM output, ignore the not-perfect saw-tooth, it's normal like this).

The response is good, just one critic: it should save the settings when powering off: after boot it always starts up with the default settings: all 4 channels active, 1V/div and 1us/div. Digital inputs off.

Probably every other DSO at power up has the settings that were left last time it was used :(

TurboTom:

--- Quote from: wat on October 01, 2018, 09:29:04 pm ---...
Probably every other DSO at power up has the settings that were left last time it was used :(

--- End quote ---

Have a look at the manual, page 19-6, "Power On". Configure this setting to "last" it should work as you are used to.

Fungus:

--- Quote from: wat on October 01, 2018, 09:29:04 pm ---Probably every other DSO at power up has the settings that were left last time it was used :(

--- End quote ---

Even the humble DS1054Z has a menu item to select that... :popcorn:

2N3055:
Press Utility  System, and then press Power On continuously to select "Last" or
"Default". By default, it is "Last".
 Last: returns to the setting of the system at last power-off.
 Default: returns to the factory setting of the system.

manual is your friend.....

wat:
Thank you guys ( :palm: ) 

Honestly I wasn't expecting it could exist an option different from "Last", I've never seen it before on any scope (or maybe I forgot about it...)
I'll read the manual, promise!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod