Products > Test Equipment
New Scope Demoboard from Batronix
<< < (29/65) > >>
Andre77:

--- Quote from: KungFuJosh on July 02, 2023, 11:52:20 pm ---I also found some leftover German in the English manuals. I haven't been paying a lot of attention, but this one stood out.

--- End quote ---

Thank you for the info! The error is now fixed.
KungFuJosh:

--- Quote from: Andre77 on July 03, 2023, 03:23:03 pm ---
--- Quote from: KungFuJosh on July 03, 2023, 12:40:16 am ---To get the 3.2 SPI interface test to work, I had to set the SS/CS channel CLK Timeout.

--- End quote ---

Your screenshot looks like you have an error on channel 1 (Chip Select). The level should not drift away like that. Have you switched on the AC coupling on this channel or do you have a contact problem?

If the chip signal is detected correctly, it also works without a CLK timeout. The CS type "CLK timeout" can be used if the CS signal is not measured (e.g. because you have a 2-channel oscilloscope or do not want to use more than 2 channels for the SPI measurement).

--- End quote ---

Oops! Looks like I missed a step. In the bottom left corner it says I had CH1 set with DC coupling. I'll go back and try that again before I move on to the RF stuff.

Thanks,
Josh

Edit: Was I supposed to have CH1 on AC also on reply 136?
Gixy:
Ordered mine this morning at breakfast. TEA is watching me... :-//
KungFuJosh:

--- Quote from: Gixy on July 03, 2023, 03:48:39 pm ---Ordered mine this morning at breakfast. TEA is watching me... :-//

--- End quote ---

Like the rest of us, it's probably @Martin72 's fault! 🤣
KungFuJosh:

--- Quote from: Andre77 on July 03, 2023, 03:23:03 pm ---Your screenshot looks like you have an error on channel 1 (Chip Select). The level should not drift away like that. Have you switched on the AC coupling on this channel or do you have a contact problem?

If the chip signal is detected correctly, it also works without a CLK timeout. The CS type "CLK timeout" can be used if the CS signal is not measured (e.g. because you have a 2-channel oscilloscope or do not want to use more than 2 channels for the SPI measurement).

--- End quote ---

Much better now. It works with "active low" and clk timeout.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod