Products > Test Equipment

New Scope Demoboard from Batronix

<< < (29/65) > >>

Andre77:

--- Quote from: KungFuJosh on July 02, 2023, 11:52:20 pm ---I also found some leftover German in the English manuals. I haven't been paying a lot of attention, but this one stood out.

--- End quote ---

Thank you for the info! The error is now fixed.

KungFuJosh:

--- Quote from: Andre77 on July 03, 2023, 03:23:03 pm ---
--- Quote from: KungFuJosh on July 03, 2023, 12:40:16 am ---To get the 3.2 SPI interface test to work, I had to set the SS/CS channel CLK Timeout.

--- End quote ---

Your screenshot looks like you have an error on channel 1 (Chip Select). The level should not drift away like that. Have you switched on the AC coupling on this channel or do you have a contact problem?

If the chip signal is detected correctly, it also works without a CLK timeout. The CS type "CLK timeout" can be used if the CS signal is not measured (e.g. because you have a 2-channel oscilloscope or do not want to use more than 2 channels for the SPI measurement).

--- End quote ---

Oops! Looks like I missed a step. In the bottom left corner it says I had CH1 set with DC coupling. I'll go back and try that again before I move on to the RF stuff.

Thanks,
Josh

Edit: Was I supposed to have CH1 on AC also on reply 136?

Gixy:
Ordered mine this morning at breakfast. TEA is watching me... :-//

KungFuJosh:

--- Quote from: Gixy on July 03, 2023, 03:48:39 pm ---Ordered mine this morning at breakfast. TEA is watching me... :-//

--- End quote ---

Like the rest of us, it's probably @Martin72 's fault! 🤣

KungFuJosh:

--- Quote from: Andre77 on July 03, 2023, 03:23:03 pm ---Your screenshot looks like you have an error on channel 1 (Chip Select). The level should not drift away like that. Have you switched on the AC coupling on this channel or do you have a contact problem?

If the chip signal is detected correctly, it also works without a CLK timeout. The CS type "CLK timeout" can be used if the CS signal is not measured (e.g. because you have a 2-channel oscilloscope or do not want to use more than 2 channels for the SPI measurement).

--- End quote ---

Much better now. It works with "active low" and clk timeout.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod