Products > Test Equipment
New Scope Demoboard from Batronix
<< < (33/65) > >>
markus_jlrb:
Dears,

get my demo board yesterday and made some first test.
I' wondering that all the testing stuff signals could be
provided by only one ic named ATSAMD20 from Microchip.
I was expecting a FPGA device on the board.



Btw have someone managed to run the I2C examp.
and see the country and capital names when selector#1
is set to 0? I'm using a SDS1104X-E and were able to
run the UART and SPI examp. but not the one mentioned
above.

Markus
Martin72:
Hi,

Besides the 2504HD, I still have a 1104 lying around... 8)

Check it today, no problems with the I²C signal...

Note:
Clock and data thresholds must both be set, approximately at 1.6V.
Can be found in the sub-item "Signals" in the decoder menu after selecting the decoder type.
I can post more pictures later.
markus_jlrb:
Thanks Martin,

you point me to the right direction.


Now I was able to decode the I2C data.


Today the SPL1016 Probes arrive too, so I could now
do some logic signal examples with the new Batronix
training board.




Markus
tautech:

--- Quote from: markus_jlrb on July 07, 2023, 07:39:44 pm ---Thanks Martin,

you point me to the right direction.


Now I was able to decode the I2C data.


Today the SPL1016 Probes arrive too, so I could now
do some logic signal examples with the new Batronix
training board.

Markus

--- End quote ---
Some tips if I may:
Idle High signal should have a falling edge trigger.
Saving screenshots to USB can be done with the blue Print button shortcut and leave the active scope menu visible and not have the Save/Recall menu instead.
markus_jlrb:
One problem appear as I have powered the demo board from the internal DSO USB connector,
so that at the same time I was not able to plug in the USB stick to save the screen shot.

I was not keen to power the demo board from a external psu as in this case the ground
layer is connected to the DSO ground.

Perhaps a USB hub will be the proper solution for this problem.

Markus
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod