Products > Test Equipment

New Scope Demoboard from Batronix

<< < (33/65) > >>

markus_jlrb:
Dears,

get my demo board yesterday and made some first test.
I' wondering that all the testing stuff signals could be
provided by only one ic named ATSAMD20 from Microchip.
I was expecting a FPGA device on the board.



Btw have someone managed to run the I2C examp.
and see the country and capital names when selector#1
is set to 0? I'm using a SDS1104X-E and were able to
run the UART and SPI examp. but not the one mentioned
above.

Markus

Martin72:
Hi,

Besides the 2504HD, I still have a 1104 lying around... 8)

Check it today, no problems with the I²C signal...

Note:
Clock and data thresholds must both be set, approximately at 1.6V.
Can be found in the sub-item "Signals" in the decoder menu after selecting the decoder type.
I can post more pictures later.

markus_jlrb:
Thanks Martin,

you point me to the right direction.


Now I was able to decode the I2C data.


Today the SPL1016 Probes arrive too, so I could now
do some logic signal examples with the new Batronix
training board.




Markus

tautech:

--- Quote from: markus_jlrb on July 07, 2023, 07:39:44 pm ---Thanks Martin,

you point me to the right direction.


Now I was able to decode the I2C data.


Today the SPL1016 Probes arrive too, so I could now
do some logic signal examples with the new Batronix
training board.

Markus

--- End quote ---
Some tips if I may:
Idle High signal should have a falling edge trigger.
Saving screenshots to USB can be done with the blue Print button shortcut and leave the active scope menu visible and not have the Save/Recall menu instead.

markus_jlrb:
One problem appear as I have powered the demo board from the internal DSO USB connector,
so that at the same time I was not able to plug in the USB stick to save the screen shot.

I was not keen to power the demo board from a external psu as in this case the ground
layer is connected to the DSO ground.

Perhaps a USB hub will be the proper solution for this problem.

Markus

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod