Products > Test Equipment
New Scope Demoboard from Batronix
<< < (34/65) > >>
tautech:

--- Quote from: markus_jlrb on July 07, 2023, 08:08:37 pm ---One problem appear as I have powered the demo board from the internal DSO USB connector,
so that at the same time I was not able to plug in the USB stick to save the screen shot.

I was not keen to power the demo board from a external psu as in this case the ground
layer is connected to the DSO ground.

Perhaps a USB hub will be the proper solution for this problem.

Markus

--- End quote ---
You do have another USB A socket on the rear......maybe not if you have SDS1202X-E.
Yes I have used a USB hub for these needs.
Martin72:
Yepp, a few hours ago I had the same "problem"... ;D
Then "wait a minute, is there another one on the back...ahh..."  8)
(You can see it on the picture, ok...not so clear)
This little puppy, I like it !

markus_jlrb:
Good hint tautech, indeed I have missed this.

Have only recognized the USB-B plug on the rear side and overseen the USB-A.

Demo board is now connected to the read side.

Thanks again.


Markus

Martin72:
The "HF" tests, now with siglent sds1104X-E..
kerouanton:

--- Quote from: pdenisowski on June 10, 2023, 09:48:08 pm ---In my experience, most people aren't aware of all the different ways of using XY mode.

--- End quote ---

Indeed, I didn't think about using X-Y mode to see IQ patterns. And happy to see that my basic SDS1204X-E does the job well on 256QAM. This makes nice screenshots, quite artistic. Thank you for your video and taking the time to explain.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod