Products > Test Equipment

New Scope Demoboard from Batronix

<< < (47/65) > >>

gf:

--- Quote from: Grandchuck on February 13, 2024, 06:58:55 pm ---Working through the demo board manual ... thought I'd share these:
Interesting demo for using Channels 1 and 3, rather than 1 and 2, for better performance.

--- End quote ---

Looks like "CH1&Ch2" suffers from aliasing (signal not sufficiently bandwidth limited for 1GSa/s).

Martin72:
Yep, he should try to measure it again with 200Mhz bandwith limit(if avaible).

Grandchuck:
The scope used is the SDS2204X HD which has a 200 MHz bandwidth.  As shown in Dave's video, Ch1 and Ch2 share one ADC and I am thinking this explains the result.
 Martin, I am on page 48 ... it has been educational.  Thanks for alerting the forum about this demo board.

Grandchuck:
Here is the delay from TP1 to TP6 on the demo board.

Martin72:
Nice,

I hadn't even tried it yet.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod