Products > Test Equipment
New Scope Demoboard from Batronix
<< < (10/65) > >>
pdenisowski:

Martin72 beat me to it, but hoping I'm the first on this side of the pond :)   I think Batronix shipped it less than an hour after I placed my order.

I'll work through the examples over the next few weeks and report back - initial impression is very positive.
Martin72:
Yeah !  :D


--- Quote ---I'll work through the examples over the next few weeks and report back
--- End quote ---

Then we can compare things between the siglent HD and the MX04..
pdenisowski:

--- Quote from: Martin72 on June 05, 2023, 05:23:26 pm ---Then we can compare things between the siglent HD and the MX04..

--- End quote ---

Sounds good.  I think I have an unfair advantage since the manual uses the MXO4 in most of its examples :) 
2N3055:

--- Quote from: Martin72 on June 05, 2023, 05:23:26 pm ---Yeah !  :D


--- Quote ---I'll work through the examples over the next few weeks and report back
--- End quote ---

Then we can compare things between the siglent HD and the MX04..

--- End quote ---

Damn you, Martin, you are typhoid Mary of demo boards...
Darn thing is coming my way too... Just ordered. I blame you.. 100% NOT my fault...

@pdenisowski,  I call your MXO4 and raise you SDS6104 H12 Pro, just to make it a bit more even...  :-DD

Truth is, I always wanted a nice demoboard as a trusted reference. This one is starting to be popular, so we can share notes...
Martin72:
Oh yeah, it´s getting more and more better.. :-+


--- Quote ---I think I have an unfair advantage since the manual uses the MXO4 in most of its examples
--- End quote ---

Pulsewidth trigger (2.4.3):
As seen on my video I get a stable trigger on the signal, but only when I trigger on the pulsewidth (appx 50µs) itself, not on the "pause" between the pulses, like the manual mentioned.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod