Products > Test Equipment
New Scope Demoboard from Batronix
<< < (14/65) > >>
Martin72:

--- Quote ---Thank You Martin  :palm: 
--- End quote ---

 ;D

You´re welcome...
But my thoughts were exactly like yours - Why, why, why...
I already got a (good) demoboard..But I couldn´t resist and now it´s here.
So far without regrets.
Men and (technical)toys...
tv84:

--- Quote from: JOSM on June 05, 2023, 09:22:10 pm ---This thread brought the wish back to life. Thank You Martin  :palm:
Waiting for UPS...

--- End quote ---

I will report this thread so that Dave can close ASAP...  >:(

Even I surfed Batronix...  :palm:   Stay away from the light......  :scared:
pdenisowski:

--- Quote from: tv84 on June 05, 2023, 09:40:57 pm ---I will report this thread so that Dave can close ASAP...  >:(

--- End quote ---

I wonder if Dave would be interested in doing a "demo boards" video - seems like a topic that would generate a lot of interest :)
pdenisowski:

--- Quote from: pdenisowski on June 05, 2023, 06:40:45 pm ---There might be one small typo:  in section 2.4.5 it says "Messen Sie das „SPI SCL“ Signal mit einem Tastkopf." (Measure the SPI SCL with a probe).

I think they meant I2C.  The SPI pin is labeled "SCK" and is idling low.  The I2C SCL signal is idling high looks exactly like the one in the manual.

--- End quote ---

Batronix has already updated the manual :)

I also reached out to them via email with a (different) question and got a very quick and helpful response, so bonus points for good customer support :)

RAPo:
This forum is expensive, another one waiting for the postman.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod