Products > Test Equipment

New Scope Demoboard from Batronix

<< < (14/65) > >>

Martin72:

--- Quote ---Thank You Martin  :palm: 
--- End quote ---

 ;D

You´re welcome...
But my thoughts were exactly like yours - Why, why, why...
I already got a (good) demoboard..But I couldn´t resist and now it´s here.
So far without regrets.
Men and (technical)toys...

tv84:

--- Quote from: JOSM on June 05, 2023, 09:22:10 pm ---This thread brought the wish back to life. Thank You Martin  :palm:
Waiting for UPS...

--- End quote ---

I will report this thread so that Dave can close ASAP...  >:(

Even I surfed Batronix...  :palm:   Stay away from the light......  :scared:

pdenisowski:

--- Quote from: tv84 on June 05, 2023, 09:40:57 pm ---I will report this thread so that Dave can close ASAP...  >:(

--- End quote ---

I wonder if Dave would be interested in doing a "demo boards" video - seems like a topic that would generate a lot of interest :)

pdenisowski:

--- Quote from: pdenisowski on June 05, 2023, 06:40:45 pm ---There might be one small typo:  in section 2.4.5 it says "Messen Sie das „SPI SCL“ Signal mit einem Tastkopf." (Measure the SPI SCL with a probe).

I think they meant I2C.  The SPI pin is labeled "SCK" and is idling low.  The I2C SCL signal is idling high looks exactly like the one in the manual.

--- End quote ---

Batronix has already updated the manual :)

I also reached out to them via email with a (different) question and got a very quick and helpful response, so bonus points for good customer support :)

RAPo:
This forum is expensive, another one waiting for the postman.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod