Products > Test Equipment

New Scope Demoboard from Batronix

<< < (17/65) > >>

Martin72:
I can show the rest tomorrow.. ;)

pdenisowski:

Here's exercise 2.7.1 (cleaning up a noisy square wave using averaging) using a HAMEG HM407 scope and average count set to 16 :)



pdenisowski:

--- Quote from: Martin72 on June 07, 2023, 05:21:13 pm ---a "joke"

--- End quote ---

Well, I make my own serial decode jokes ...  :)  Bidirectional UART message exchange.

Edit:  Two Arduinos (Arduini?) talking to each other.  Code attached.

pdenisowski:
I tried out the low speed serial data today (SPI, I2C, UART) and they all look good.  Joke is actually kind of funny (and in English), but is the same for all bus types  :(

I used the mixed signal option of the MXO4 and a logic probe to connect to the demo board:  no issues at all.  It's nice having the ability to use both "normal" and logic probes.

I'm going to skip the automotive protocols for now and try the FFT:  I think / hope that will be the most interesting demo.

Martin72:
Wow, such a table i want to have it on my HD !  :D
For the whole joke I must take three pictures... :(
Visibility is poor on siglent scopes... :P
Plus I didn´t get a stable signal, it´s always jittering fast (must test it tomorrow on the lecroy, if I overlooked this).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod