| Products > Test Equipment |
| New Scope Demoboard from Batronix |
| << < (18/65) > >> |
| pdenisowski:
I also tried out the 8-bit parallel bus. This is another thing that is hard to create for demonstrations. Also worked fine :) I had hoped to quickly work through all the demos in my idle moments (after all, I'm using the same scope for most of them :)) but it's becoming clear that this board has a lot of functionality and that it would be best for me to spend some "quality time" with it rather than just check off the exercises one by one. |
| Martin72:
Serial decodings: Did you get a "jitterfree" stable signal on your scope ? |
| tautech:
--- Quote from: Martin72 on June 07, 2023, 08:22:33 pm ---Serial decodings: Did you get a "jitterfree" stable signal on your scope ? --- End quote --- One wonders about user settings from where the H Pos maker is. |
| Martin72:
Has nothing to do with it, it does not matter where the position is. It's always like a very fast pwm, I'll have to test that again tomorrow on the lecroy, maybe I had overlooked it on that one today. When you have plenty of packets on the screen then it doesn´t matter. |
| Martin72:
Trying the same with now all four channel instead of two (Miso, Mosi, Sclk, CS), still "running". But one thing to know, regardless if 2 or 4 channel spi, the siglent decodes everything proper - If you look "fast enough", you can read the values and they´re correct. ;) |
| Navigation |
| Message Index |
| Next page |
| Previous page |