Products > Test Equipment

New Scope Demoboard from Batronix

<< < (18/65) > >>

pdenisowski:
I also tried out the 8-bit parallel bus.  This is another thing that is hard to create for demonstrations.

Also worked fine :)

I had hoped to quickly work through all the demos in my idle moments (after all, I'm using the same scope for most of them :)) but it's becoming clear that this board has a lot of functionality and that it would be best for me to spend some "quality time" with it rather than just check off the exercises one by one.

Martin72:
Serial decodings:
Did you get a "jitterfree" stable signal on your scope ?

tautech:

--- Quote from: Martin72 on June 07, 2023, 08:22:33 pm ---Serial decodings:
Did you get a "jitterfree" stable signal on your scope ?

--- End quote ---
One wonders about user settings from where the H Pos maker is.

Martin72:
Has nothing to do with it, it does not matter where the position is.
It's always like a very fast pwm, I'll have to test that again tomorrow on the lecroy, maybe I had overlooked it on that one today.
When you have plenty of packets on the screen then it doesn´t matter.

Martin72:
Trying the same with now all four channel instead of two (Miso, Mosi, Sclk, CS), still "running".
But one thing to know, regardless if 2 or 4 channel spi, the siglent decodes everything proper - If you look "fast enough", you can read the values and they´re correct. ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod