Products > Test Equipment
New Siglent SPD4000X series power supply
KungFuJosh:
--- Quote from: mawyatt on November 06, 2024, 02:22:54 am ---our CEO/CFO/Boss as just a unique coincidence ;)
--- End quote ---
Does that mean "the wife?" :-DD
mawyatt:
:-+
tautech:
Freshly arrived SPD4306X tests.
FW V4.1.2.8R1
Measurements taken with DP-35 differential probe @ 20:1 to eliminate any chance of Gnd bounce abnormalities.
Probe Check not run to remove any amplitude error.
Single shot captures.
Output set to OFF and for 2V 30mA on Ch1 (15V 1.5A max)
Unloaded output except for Diff probe
Mains power ON
Ch1 ON into 50 Ohm 3/4" banana load.
mawyatt:
That looks good, so Siglent must have addressed these "Output Voltage Glitch" issues with the new firmware release :-+
If so, this demonstrates Siglent is "listening" and responding quickly with important updates that address serious issues such as this, so kudos to Siglent :clap:
Hopefully others will follow up!!
Best
sparky2024:
Hi @mawyatt, Unfortunately V4.1.2.8R1 did not solve the issue on my SPD4323X. Does anyone else have the SPD4323X, and do they have the same issue with power glitch when mains power is turned off, at channels 2 & 3?
Thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version