Products > Test Equipment
New UNI-T UT210E PRO problem
<< < (7/9) > >>
Trader:

--- Quote from: Stinger on November 13, 2020, 11:45:15 am ---Hello,

This new UT-210E Pro can measure frequencies and see more capacitance. The UT-211B with 6000 counts can this.

I hope it can be hackable like classic version.

--- End quote ---

Any reason for the UNI-T UT211B to cost around 2x the price of UT210E Pro, since they have basically the same features? (the only significative difference is 6k vs 2k counts, but you can hack the UT210E to up 10k counts)
Stinger:
The UT-211B are overpriced. No standard fuses for cost.
But he can measure current at 6000 counts in mA when zeroing offset display.
odarek:
Hi sky666,

could you please unscrew the back cover and take some photos with components ids and put them here?
so that we can compare your version of the meter "UT-210E PRO" with model "UT-210E" (without PRO)

Have you tried to improve your meter?

Best regards,
Darek
Gaft:

--- Quote from: odarek on February 11, 2021, 06:09:53 pm ---Hi sky666,

could you please unscrew the back cover and take some photos with components ids and put them here?
so that we can compare your version of the meter "UT-210E PRO" with model "UT-210E" (without PRO)

Have you tried to improve your meter?

Best regards,
Darek

--- End quote ---


here is my uni-t ut210e
jfiresto:

--- Quote from: Trader on November 14, 2020, 02:13:19 am ---Any reason for the UNI-T UT211B to cost around 2x the price of UT210E Pro, since they have basically the same features? (the only significative difference is 6k vs 2k counts, but you can hack the UT210E to up 10k counts)

--- End quote ---

The UT-211B advertises 0.1mA resolution and can potentially measure such low currents, which makes it "perfect for anyone requiring high precision and accurate results when working with electronics, such as troubleshooting solar power systems current load, electrical cars, etc.". If you dig into the product manual, however, you discover its high resolution (and stated accuracy) is only for AC. Was it meant to have 0.1mA resolution on DC? I tend to the notion that measuring low DC currents with a clamp-on meter is not that easy.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod