Products > Test Equipment

ngscopeclient - Ultimate acquisition software / protocol decoder / debug tool ?

<< < (3/11) > >>

egonotto:

--- Quote from: macaba on September 12, 2024, 02:34:55 pm ---Try

cd build
cmake --build . -j4

--- End quote ---

Hello,

Thanks it compiles now, but it's taking quite a while.

Best regards
egonotto
PS: Now it's ready. But my SDS3000X HD is not recognized correctly via LAN.
ERROR: Unknown scope type

fredo_:

--- Quote from: egonotto on September 12, 2024, 04:16:29 pm ---PS: Now it's ready. But my SDS3000X HD is not recognized correctly via LAN.
ERROR: Unknown scope type

--- End quote ---
Sorry I should have told you that egonotto, I did not add SDS3000X HD to the Siglent driver yet, it's next on my TODO list.
I'll let you know when it's done and merged to ngscopeclient repo.
 

egonotto:

--- Quote from: fredo_ on September 12, 2024, 05:04:07 pm ---
--- Quote from: egonotto on September 12, 2024, 04:16:29 pm ---PS: Now it's ready. But my SDS3000X HD is not recognized correctly via LAN.
ERROR: Unknown scope type

--- End quote ---
Sorry I should have told you that egonotto, I did not add SDS3000X HD to the Siglent driver yet, it's next on my TODO list.
I'll let you know when it's done and merged to ngscopeclient repo.

--- End quote ---

Hallo,

Thank you, no problem. I just wanted to see if the program would run and then saw that Siglent was included and entered the IP of my SDS3000X HD.

Best regards
egonotto

shabaz:

--- Quote from: egonotto on September 12, 2024, 02:32:24 pm ---Hello,

I wanted to install it in Windows, but the last step doesn't work.

In GettingStarted step 7 they say:
"
All following steps are to be done in a UCRT64 shell.

7.
Build manually:
cd scopehal-apps
mkdir build
cd build
cmake ..
make -j4
"
This works well up to and including cmake .
But the command make -j4 does not work.
At first it did not find make. I installed it with pacman -S make. Now the error message appears:
$ make -j4
make: *** No targets specified and no makefile found.  Stop.

Has anyone translated it for Windows yet?
Does anyone have any idea what I should do?

Best regards
egonotto

--- End quote ---


Sorry I just saw this now : (
As someone mentioned earlier, using ninja resolved it. i.e. this worked for me (instead of the make command):


--- Code: ---cmake -G "Ninja" ..
ninja

--- End code ---

Also, for me it didn't initially run because I was missing the following in the PATH user variables, and it couldn't find some DLLs:


--- Code: ---C:\msys64\ucrt64\bin

--- End code ---

Once I added that to PATH, then it ran. But currently USBTMC isn't supported on Windows, so I'm going to find that quite limiting (I appreciate that it may not be an issue at all for most).

egonotto:
Hello,

thanks to all, the suggestion from macaba
“Try

cd build
cmake --build . -j4”

worked without any problems.
I was able to call the generated program without any problems.

Best regards
egonotto

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod