Products > Test Equipment
OCXO tuning screws not working on old equipment
<< < (7/8) > >>
807:
It always surprises me when I see so many videos on youtube where small screwdrivers are used to adjust trimmer pots & capacitors. The screwdriver slips & slides all over the place.

I've been using one of these for decades. It's open one end & enclosed the other end. Stops the blade from sliding off the trimmer.
techneut:
I know these, they came with HP probes. I have at least one, somewhere
trobbins:
Mine has RS stamped on it.
Thomas:
On the Racal Dana 1992:
You do realize the two screws visible from the back of the counter are covers, right?
The actual trimmers are visible after removing these.
tverbeure:

--- Quote from: Thomas on July 03, 2023, 10:56:46 am ---On the Racal Dana 1992:
You do realize the two screws visible from the back of the counter are covers, right?
The actual trimmers are visible after removing these.

--- End quote ---
I don't think the screws that are marked NE and COAR are covers?

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod