Products > Test Equipment

OCXO tuning screws not working on old equipment

<< < (7/8) > >>

807:
It always surprises me when I see so many videos on youtube where small screwdrivers are used to adjust trimmer pots & capacitors. The screwdriver slips & slides all over the place.

I've been using one of these for decades. It's open one end & enclosed the other end. Stops the blade from sliding off the trimmer.

techneut:
I know these, they came with HP probes. I have at least one, somewhere

trobbins:
Mine has RS stamped on it.

Thomas:
On the Racal Dana 1992:
You do realize the two screws visible from the back of the counter are covers, right?
The actual trimmers are visible after removing these.

tverbeure:

--- Quote from: Thomas on July 03, 2023, 10:56:46 am ---On the Racal Dana 1992:
You do realize the two screws visible from the back of the counter are covers, right?
The actual trimmers are visible after removing these.

--- End quote ---
I don't think the screws that are marked NE and COAR are covers?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod