Products > Test Equipment
open source GPIB adapter
dazz1:
--- Quote from: coromonadalix on May 18, 2023, 09:03:20 am ---My 2 cent comment would have been to provide some pads for say rgb or 2 color led 3mm or 5 mm led ...
--- End quote ---
PCB mount indicators like this one:
https://us.rs-online.com/product/dialight/550-5207f/70081710/
look like good candidates.
I have had a quick tour through the code, and it looks like it would not be too difficult to add LED status for various actions.
coromonadalix:
a last comment loll
would it be better to use a 10 pin variant of the jtag ISP instead of the 6 pin
because many many adapters / programmers come with the 10 pins and you have to do some battle to get the 10 to 6 pin converter or find programmers in the 6 pin variants
happened to me and was frustrating ...
another 2 cents
willing to buy assembled board ?? or you'll provide the bare board gerbers etc ???
dazz1:
Hi
I have a programmer on order from Aliexpress, complete with the necessary adapter.
The extra 4 pins of a 10 pin header would take up quite a bit of real-estate on the pcb.
dazz1:
--- Quote from: coromonadalix on May 18, 2023, 11:05:47 am ---
willing to buy assembled board ?? or you'll provide the bare board gerbers etc ???
--- End quote ---
I will buy the bare board and assemble myself for my own use.
I hadn't considered making/selling them.
Most parts come in 5's but I only need 3 adapters. I expect to have at least 2 spare boards plus parts left over.
This is a very niche item.
dreamcat4:
--- Quote from: dazz1 on May 18, 2023, 11:10:27 am ---Hi
I have a programmer on order from Aliexpress, complete with the necessary adapter.
The extra 4 pins of a 10 pin header would take up quite a bit of real-estate on the pcb.
--- End quote ---
Could please provide link to the programmer you ended up ordering? Many thanks
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version