Products > Test Equipment
Open source lxi-tools and liblxi v1.0 released for GNU/Linux
<< < (20/67) > >>
lundmar:

--- Quote from: dpenev on November 30, 2017, 12:21:29 pm ---Hello,

I got this:
dpenev@yni:~$ sudo snap refresh lxi-tools --edge     
snap "lxi-tools" has no updates available
dpenev@yni:~$ lxi -v
lxi v1.13

--- End quote ---

Thats's good. On some systems snaps automatically updates to the latest version available in their active channel (stable, candidate, beta, or edge).


--- Quote from: dpenev on November 30, 2017, 12:21:29 pm ---dpenev@yni:~$ lxi screenshot -a 192.168.1.61   
Loaded siglent-ssa3000x screenshot plugin
Error: Failed to receive message
dpenev@yni:~$

--- End quote ---

Hmm. It looks like your SSA3000X instrument does not respond to or recognize the "SCDP." command.

I also notice you seem to be running the latest firmware :-+

I'll talk to Siglent again to verify that the "SCDP." command is actually supported by latest public firmware.

Thanks for testing.
lundmar:
FYI - I've updated the original post that started this thread to include install instructions/hints for getting lxi-tools working with Windows.

Perhaps some would like to share their experience with VMs and lxi-tools.
dpenev:
Hi Lundmar,

I don't find SCDP command in the SSA3000X programming manual.
lundmar:

--- Quote from: dpenev on November 30, 2017, 09:16:29 pm ---Hi Lundmar,

I don't find SCDP command in the SSA3000X programming manual.

--- End quote ---

Hi,

True - I'm told it is an undocumented command that should work with SSA3000X. However, I suspect that maybe it is only available in firmware that has not been released yet. I'll check with Siglent to make sure and get back to you. It would be nice if we could get the screenshot plugin working seamlessly with this nice instrument.
lundmar:

--- Quote from: dpenev on November 30, 2017, 09:16:29 pm ---I don't find SCDP command in the SSA3000X programming manual.

--- End quote ---

I've updated the siglent-ssa3000x plugin - I've added some termination characters to the capture command which might make a difference for this particular instrument.

Let me know if that gets it going.

FYI - snap revision 110 or later:


--- Code: ---$ snap info lxi-tools
name:      lxi-tools
summary:   Open source LXI tools
publisher: lundmar
description: |
  Lxi-tools is a collection of open source software tools that enables control
  of LXI compatible instruments such as modern oscilloscopes, power supplies,
  spectrum analyzers etc.
snap-id: yha3V4dqfwJwpjSWgMFEMViAlQ2iMdL7
commands:
  - lxi-tools.lxi
tracking:    edge
installed:   1.13 (110) 14MB -
refreshed:   2017-12-01 02:08:58 +0100 CET
channels:               
  stable:    1.12 (42)  14MB -
  candidate: ?               
  beta:      ?               
  edge:      1.13 (110) 14MB -

--- End code ---
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod