Products > Test Equipment

Oscilloscope recommendation DS1054Z / SDS1104X-E / GDS-1104B / etc?

<< < (7/23) > >>

nctnico:

--- Quote from: Martin72 on June 10, 2023, 09:53:21 pm ---
--- Quote from: Fungus on June 08, 2023, 09:20:52 pm ---Siglent's system for turning on measurements is a real pain in the ass by comparison.

--- End quote ---

Which model did/have you had and with which other scopes did you compare it ?

--- End quote ---
Actually it is very easy to see. Any oscilloscope with a vertical AND horizontal row of buttons is way easier to navigate compared to an oscilloscope with only a single row of buttons. On top of that an oscilloscope with a seperated rotating knob / select button is easier to use compared to an oscilloscope with a combined button. GW Instek really comes out on top where it comes to ease of use for setting up measurements and decoding. Ofcourse things are different if the oscilloscope has a touchscreen but then you;d need to look at MicSig for a sub US$ 1k scope.

Martin72:
It´s about making measurements or did I missunderstood something ?
The old debate about pros and cons having separate adjustment knobs for each channel is another thing.

nctnico:

--- Quote from: Martin72 on June 10, 2023, 11:03:15 pm ---It´s about making measurements or did I missunderstood something ?

--- End quote ---
You understood correctly; you need to go through menus to set these up. Easy menu access = easy to do measurements

tautech:

--- Quote from: Martin72 on June 10, 2023, 09:53:21 pm ---
--- Quote from: Fungus on June 08, 2023, 09:20:52 pm ---Siglent's system for turning on measurements is a real pain in the ass by comparison.

--- End quote ---

Which model did/have you had and with which other scopes did you compare it ?

--- End quote ---
None !

You already know it's simple, set the measurements you need and the source from which they are taken and they are returned at every boot and whenever you cycle Measurements ON again.

Martin72:
Yep,
It's really easy and "quick", I had just tried it out briefly because I was taking pictures for the demo board thread.
Press Measure, select source, select parameters, done in a few seconds, could make a short video clip from it, if wanted.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod