Products > Test Equipment
Oscilloscope Zoom Out Quirk
<< < (113/113)
Fungus:

--- Quote from: electr_peter on November 01, 2022, 02:29:56 pm ---Memory size, sampling rate and time division settings are always shown on a screen and you can mentally calculate if the is data beyond the screen.

--- End quote ---

Alternatively: Just look at the little indicator at the top...  :)


electr_peter:
Good point, these icons represent memory situation clearly.
teddychn:

--- Quote from: 2N3055 on October 20, 2022, 11:33:46 am ---
--- Quote from: EEVblog on October 20, 2022, 09:25:27 am ---
--- Quote from: dreamcat4 on October 20, 2022, 08:49:18 am ---
--- Quote from: tautech on October 20, 2022, 08:21:53 am ---Memory management and its options/guises are a recently added feature to SDS5000X in the FW version V0.9.7R2 before last.
It was developed in SDS2000X HD and SDS6000A.

--- End quote ---
aah interesting... so maybe it could be coming to any other remaining models featuring same / similar shared firmware platform? Or perhaps it requires a specific set of hardware common in those listed above? ^^

--- End quote ---

It would be an FPGA capture architecture thing I think, not the processor firmware as such.

--- End quote ---

That is correct.

--- End quote ---

I think Siglent can make it with tweaking the zoom mode. IMHO, just turn the upper-split screen into a time zone strip and that might do the trick. I guess it depends on Siglent's decision rather than architecture limitation.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod