Products > Test Equipment

Oscilloscope Zoom Out Quirk

<< < (113/113)

Fungus:

--- Quote from: electr_peter on November 01, 2022, 02:29:56 pm ---Memory size, sampling rate and time division settings are always shown on a screen and you can mentally calculate if the is data beyond the screen.

--- End quote ---

Alternatively: Just look at the little indicator at the top...  :)


electr_peter:
Good point, these icons represent memory situation clearly.

teddychn:

--- Quote from: 2N3055 on October 20, 2022, 11:33:46 am ---
--- Quote from: EEVblog on October 20, 2022, 09:25:27 am ---
--- Quote from: dreamcat4 on October 20, 2022, 08:49:18 am ---
--- Quote from: tautech on October 20, 2022, 08:21:53 am ---Memory management and its options/guises are a recently added feature to SDS5000X in the FW version V0.9.7R2 before last.
It was developed in SDS2000X HD and SDS6000A.

--- End quote ---
aah interesting... so maybe it could be coming to any other remaining models featuring same / similar shared firmware platform? Or perhaps it requires a specific set of hardware common in those listed above? ^^

--- End quote ---

It would be an FPGA capture architecture thing I think, not the processor firmware as such.

--- End quote ---

That is correct.

--- End quote ---

I think Siglent can make it with tweaking the zoom mode. IMHO, just turn the upper-split screen into a time zone strip and that might do the trick. I guess it depends on Siglent's decision rather than architecture limitation.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod