Products > Test Equipment
OWON / VEVOR SDS1102 probe tips
(1/2) > >>
Elecmuso:
Is there a trick to removing the tips on the provided scope probes (OW3100)? I have tried with a lot of force to pull them off, any more force I feel could damage them. Is it just a case of pulling harder??!!
thm_w:
Some probe tips unscrew, some probe tips unclip.
Try to unscrew them first, if they just spin forever then they should unclip and you just need to pull a bit harder. They may get easier with use.

Fairly sure those are clip ones, you could check the manual too if there is one.
Elecmuso:
Cheers. Already checked / searched the scope manual and the separate manual for the probes. Not mentioned anywhere!
Aldo22:
The first time they are often a bit tough.
I had my doubts too, but it worked with pulling. (But they were not from Owon)

Do they look like this? (From: https://www.amazon.de/OWON-HDS200-Handoszilloskop-Labor-Oszilloskope/dp/B0BX6KMYM2?th=1 )

TizianoHV:
I have an OWON VDS1022I too. I had the same problem. If you want to remove the tip you have to pull a LOT.

After some time they started making bad contact and I had to repair them. So you should avoid remooving them often.

Now I just keep one with the tip and the other without.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod