Products > Test Equipment
Philips PM3565 and 3570
<< < (3/4) > >>
Inside21:
sorry for question: how much channels & speed u need for real work?
i have hantek 6022 + sigrok software and dont need any  more for work.
https://sigrok.org/wiki/Protocol_decoders
https://sigrok.org/wiki/Supported_hardware
Norbert67:
It would be great if I could measure parallel communications as well as serial. So I think 32 channel would be adequate.
Norbert67:
And around 50 to 100Mhz
Inside21:
= Hantek 4032
32 channels, 150 MHz, 2Gb depth
and it does not take up space on the table  :D
Norbert67:
It looks good. But why does everybody using the sigrok software? Is it any better?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod