EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: LootMaster on October 27, 2020, 05:02:35 am

Title: Playing Doom on MSO5074
Post by: LootMaster on October 27, 2020, 05:02:35 am

So I was thinking...

Next time my buddy comes over, I'll be like...

Ok, I have something important to show you that I found out...

Then I'll open the scope, all serious, then I'll proceed to play doom.  :-DD

No seriously, how do you install it, and how do you hack this thing.

Does somebody have a few lines with required details easy instructions please?? That other thread is all over the place. :scared:

Firmware: 01.03.00.01
Hardware: 01.01.000

Title: Re: Playing Doom on MSO5074
Post by: ledtester on October 27, 2020, 06:43:14 am

This video:

https://youtu.be/m2JOs0Aldq0

refers to tis github repo:

https://github.com/Spritetm/prboom-mso5k

Title: Re: Playing Doom on MSO5074
Post by: LootMaster on October 27, 2020, 11:30:44 am

Actually I dont care about that...Doom.

What mouse clicks must I do to hack my scope?

I never ever installed Linux nor went into cmd things.

Title: Re: Playing Doom on MSO5074
Post by: LootMaster on October 27, 2020, 09:31:10 pm

Please...Help...me  :'(

Title: Re: Playing Doom on MSO5074
Post by: maginnovision on October 27, 2020, 09:46:02 pm

Nobody here can provide the help you need I'm afraid. You seem to need someone to come to your house and hold your hand while they do the work.

Title: Re: Playing Doom on MSO5074
Post by: LootMaster on October 27, 2020, 10:45:37 pm

Oh no you can help...

That is the attitude of Sodom and Gomorrah.

When you see a poor beggar, you see God who is poor and begging.

Plz...help...me :'(

Title: Re: Playing Doom on MSO5074
Post by: maginnovision on October 27, 2020, 11:12:10 pm

You've convinced me. Send me your scope and I'll get it done asap.

Title: Re: Playing Doom on MSO5074
Post by: ledtester on October 27, 2020, 11:27:14 pm

Quote from: LootMaster on October 27, 2020, 11:30:44 am

Actually I dont care about that...Doom.

What mouse clicks must I do to hack my scope?

I never ever installed Linux nor went into cmd things.

You don't have to install Linux - just follow the instructions in the github repo to get to a command prompt. There are no mouse clicks involved -- you just ssh into the machine.