Products > Test Equipment
Possible GW Instek GDS-1000B hack
<< < (25/52) > >>
TK:
False Alarm... it was a bad BNC cable   |O |O |O.  Self Calibration works OK on firmware 1.23 (and 1.12 as well).
nctnico:
Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.
Mortymore:
If I recall correctly, I think Bob Pease once said that he marked bad components with a hammer.
If left lying around unmarked, they tend to be inserted again on a circuit.
rf-loop:

--- Quote from: nctnico on May 03, 2019, 03:48:12 pm ---Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.

--- End quote ---

Oh you want more bad crap BNC cables.  :-DD
nctnico:

--- Quote from: rf-loop on May 03, 2019, 05:29:12 pm ---
--- Quote from: nctnico on May 03, 2019, 03:48:12 pm ---Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.

--- End quote ---
Oh you want more bad crap BNC cables.  :-DD

--- End quote ---
Well the cables I get from Ebay are way better then what I bought locally (unless you go for the utterly cheap ones on Ebay). Cables are consumables anyway.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod