Products > Test Equipment
Possible GW Instek GDS-1000B hack
TK:
False Alarm... it was a bad BNC cable |O |O |O. Self Calibration works OK on firmware 1.23 (and 1.12 as well).
nctnico:
Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.
Mortymore:
If I recall correctly, I think Bob Pease once said that he marked bad components with a hammer.
If left lying around unmarked, they tend to be inserted again on a circuit.
rf-loop:
--- Quote from: nctnico on May 03, 2019, 03:48:12 pm ---Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.
--- End quote ---
Oh you want more bad crap BNC cables. :-DD
nctnico:
--- Quote from: rf-loop on May 03, 2019, 05:29:12 pm ---
--- Quote from: nctnico on May 03, 2019, 03:48:12 pm ---Cut the cable in half and throw it away. BNC cables are plentyful and cheap on Ebay.
--- End quote ---
Oh you want more bad crap BNC cables. :-DD
--- End quote ---
Well the cables I get from Ebay are way better then what I bought locally (unless you go for the utterly cheap ones on Ebay). Cables are consumables anyway.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version