Products > Test Equipment
Possible GW Instek GDS-1000B hack
<< < (27/52) > >>
ttyridal:
It's possible I overlooked something of course.

I just replaced the four numbers in lis.txt (reply #3) with the ones given in reply #47

Reasonably sure I had the serial number correct both times (no homoglyphs in it)
TK:
It did not work on my GDS-1054B with firmware 1.23 

I had to downgrade it to 1.12, apply the hack and upgrade to 1.23

And upgrade does not work when executed from the utility menu, it only works when using SAFE MODE.

But fortunately using SAFE MODE you can downgrade and upgrade from any version to any other version.

I also tested SSH on 1.12 to remove the options file and it works OK.
tv84:
Sorry guys, maybe I overlooked something and there is another combination...   ::)

uint[] ClearCode = { 0x3D1B58BA, 0x74B0DC51, 0x19495CFF, 0x257130A3 };

Can anyone test this with a v1.23 ?

Edit1:

Thanks wgoeo for the test. It seems i mixed the order...  :palm:  Endianess stuff...

So the correct order is:

uint[] ClearCode = { 0x19495CFF, 0x257130A3, 0x3D1B58BA, 0x74B0DC51 };
TK:

--- Quote from: tv84 on May 07, 2019, 08:11:00 pm ---Sorry guys, maybe I overlooked something and there is another combination...   ::)

uint[] ClearCode = { 0x3D1B58BA, 0x74B0DC51, 0x19495CFF, 0x257130A3 };

Can anyone test this with a v1.23 ?

--- End quote ---
It doesn't work.  I downgraded to 1.12, connected using ssh, removed OptionsConf file to remove previous licenses, upgraded to 1.23 using SAFE MODE, tried applying new license code but it gives the same error.
frogblender:

--- Quote from: TK ---
--- End quote ---
TK....  what's the latest with your GDS-1054B?   Is the hack working, and if so, what is your BW?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod