Products > Test Equipment
Possible GW Instek GDS-1000B hack
<< < (32/52) > >>
Mortymore:

--- Quote from: stafil on April 02, 2020, 11:35:41 pm ---Sorry, I got lost. If I get GDS-2074E can I use the keygen to upgrade it to 200Mhz?

--- End quote ---

If you wish to go to 300MHz, install that license. If you go to 200MHz it will not be straightforward to upgrade to 300MHz afterwords.

Check my experience on that

Don't forget to install the Spectrum Analyzer also. It will give that OPTION button some good use.
Good luck  :-+
idolclub:
GW Instek Releases New Firmware v1.27 for GDS-1000B series.

Firmware v1.27 Release Notes:

1.Enabled BUS Features.

2.Fixed UART minor bug.

3.Fixed Datalog error at low frequency signals.

4.Fixed the Portuguese translations.

5.Fixed the Japanese translations.


https://www.gwinstek.com/en-GB/products/detail/GDS-1000B

Mortymore:
They also added a new version 1.03 of OpenWave for the GDS-1000B

And new firmware v1.41 for the GDS-2000E  :-+
paul002:
Took some time to read all the post, but now 300 Mhz !! :)
77algernon:
 :) I can confirm that the 200MHz upgrade works on the MDO-2074EG with 1.41 firmware (I used the data from reply #47)


Thanks to all the good ppl contributing to this thread!

Just a quick question: anyone tried to enable the FFT entries from the Function Module menu? It has something to do with the option_index?


L.E.

It seems the FFT entries from the Function Module menu are in fact apps, which you can download from the GDS-2000E section: https://www.gwinstek.com/en-global/products/detail/GDS-2000E It seems it requires one to register with GWInstek, though.

Just unzip and copy the .fun file on the USB stick, then install it by selecting twice in the File Utilities menu. I installed only the dual display app.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod