Products > Test Equipment
Possible GW Instek GDS-1000B hack
<< < (33/52) > >>
nctnico:

--- Quote from: paul002 on May 05, 2020, 03:13:01 pm ---Took some time to read all the post, but now 300 Mhz !! :)

--- End quote ---
Did you also try to enable protocol decoding (serial decode option)?
77algernon:

--- Quote from: nctnico on May 07, 2020, 12:31:46 pm ---Did you also try to enable protocol decoding (serial decode option)?

--- End quote ---

Hi, the MDO-s seem to have a dedicated button for bus decoding, guess it's already enabled? Or it seems that way, at least :)
nctnico:

--- Quote from: 77algernon on May 07, 2020, 12:58:38 pm ---
--- Quote from: nctnico on May 07, 2020, 12:31:46 pm ---Did you also try to enable protocol decoding (serial decode option)?

--- End quote ---

Hi, the MDO-s seem to have a dedicated button for bus decoding, guess it's already enabled? Or it seems that way, at least :)

--- End quote ---
You can try to press it... AFAIK decoding is not available on the MDO2000 series but it could be GW Instek has enabled it anyway.
77algernon:
I have the MDO-2074EG and pressing the "Bus" button shows the following:


I have no experience with any other GWInstek scope, so I don't know if it's the same feature as the one that serial bus decoding unlocks on the DSO models.
nctnico:
OK, the MDO series seems to have decoding as well. Thanks for trying!
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod