Products > Test Equipment

Possible GW Instek GDS-1000B hack

<< < (33/52) > >>

nctnico:

--- Quote from: paul002 on May 05, 2020, 03:13:01 pm ---Took some time to read all the post, but now 300 Mhz !! :)

--- End quote ---
Did you also try to enable protocol decoding (serial decode option)?

77algernon:

--- Quote from: nctnico on May 07, 2020, 12:31:46 pm ---Did you also try to enable protocol decoding (serial decode option)?

--- End quote ---

Hi, the MDO-s seem to have a dedicated button for bus decoding, guess it's already enabled? Or it seems that way, at least :)

nctnico:

--- Quote from: 77algernon on May 07, 2020, 12:58:38 pm ---
--- Quote from: nctnico on May 07, 2020, 12:31:46 pm ---Did you also try to enable protocol decoding (serial decode option)?

--- End quote ---

Hi, the MDO-s seem to have a dedicated button for bus decoding, guess it's already enabled? Or it seems that way, at least :)

--- End quote ---
You can try to press it... AFAIK decoding is not available on the MDO2000 series but it could be GW Instek has enabled it anyway.

77algernon:
I have the MDO-2074EG and pressing the "Bus" button shows the following:


I have no experience with any other GWInstek scope, so I don't know if it's the same feature as the one that serial bus decoding unlocks on the DSO models.

nctnico:
OK, the MDO series seems to have decoding as well. Thanks for trying!

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod