Products > Test Equipment
Possible GW Instek GDS-1000B hack
<< < (34/52) > >>
paul002:
Sorry for late reply, but I think it serial decoding is already enabled. I could decode SPI as in attached picture.
robohead:
Has anyone come up with a solution to the "To install this option you must use the GW USB key." error?

I just got a 1054B and wanted to install the 100MHz upgrade.

In case it helps I'm using firmware v1.12 and the safe mode screen says I have FPGA version 77
espenfjo:
So.. with these upgrades.. Does this mean that we can upgrade an GDS-1054B to an eg. an GDS-1104B, or even an GDS-2204E? Or are there other differences between these scopes that we are not able to upgrade? Such as rise time, memory, sw features etc?
2N3055:

--- Quote from: espenfjo on July 18, 2020, 05:37:00 pm ---So.. with these upgrades.. Does this mean that we can upgrade an GDS-1054B to an eg. an GDS-1104B, or even an GDS-2204E? Or are there other differences between these scopes that we are not able to upgrade? Such as rise time, memory, sw features etc?

--- End quote ---

GDS-1054B is same as GDS-1104B
GDS-2204E is different scope..
idolclub:
GW Instek Releases New Firmware v1.28 for GDS-1000B series.

Firmware v1.28 Release Notes:

1. Fixed a freeze issue that could occur when switching to PictBridge printing.

2. Fixed a bug for the BUS trigger mode.


https://www.gwinstek.com/en-GB/products/detail/GDS-1000B
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod