Products > Test Equipment
Possible GW Instek GDS-1000B hack
paul002:
Sorry for late reply, but I think it serial decoding is already enabled. I could decode SPI as in attached picture.
robohead:
Has anyone come up with a solution to the "To install this option you must use the GW USB key." error?
I just got a 1054B and wanted to install the 100MHz upgrade.
In case it helps I'm using firmware v1.12 and the safe mode screen says I have FPGA version 77
espenfjo:
So.. with these upgrades.. Does this mean that we can upgrade an GDS-1054B to an eg. an GDS-1104B, or even an GDS-2204E? Or are there other differences between these scopes that we are not able to upgrade? Such as rise time, memory, sw features etc?
2N3055:
--- Quote from: espenfjo on July 18, 2020, 05:37:00 pm ---So.. with these upgrades.. Does this mean that we can upgrade an GDS-1054B to an eg. an GDS-1104B, or even an GDS-2204E? Or are there other differences between these scopes that we are not able to upgrade? Such as rise time, memory, sw features etc?
--- End quote ---
GDS-1054B is same as GDS-1104B
GDS-2204E is different scope..
idolclub:
GW Instek Releases New Firmware v1.28 for GDS-1000B series.
Firmware v1.28 Release Notes:
1. Fixed a freeze issue that could occur when switching to PictBridge printing.
2. Fixed a bug for the BUS trigger mode.
https://www.gwinstek.com/en-GB/products/detail/GDS-1000B
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version