Products > Test Equipment
Possible GW Instek GDS-1000B hack
Mortymore:
--- Quote from: slodat on March 24, 2019, 02:32:13 am ---Does anyone have 1.12 they would be willing to share with me? I have a GDS-1054B.
Thanks in advance!
--- End quote ---
Hi slodat
I believe you still can get it following the provided link on the 1st post of this thread.
nctnico:
--- Quote from: slodat on March 24, 2019, 02:32:13 am ---Does anyone have 1.12 they would be willing to share with me? I have a GDS-1054B.
Thanks in advance!
--- End quote ---
A few pages back there is a new key generator so you don;t have to downgrade.
slodat:
I’ve read the thread about thirty times. I can’t get the first lis.html to produce a license file on any browser I have. It just says failed to download.
And, I don’t know where the post 47 code snippet would be used. I’m not following. Anyone up for helping a guy out?
Mortymore:
You probably are not actually changing the extension file from TXT to HTML. If using Windows you need to enable to show file extensions on folder options.
Don't downgrade the firmware and try to generate licences with the attached file DS1KB.txt, after rename it's extension from txt to html.
Hope I get it right. This should work for firmware above v1.18 of the 1000B, but you must expect that some of the licences won't probably work, like Power Analysis or BW300. You are free to try them all, though. If they don't work, no harm done.
You will need to know the serial number of your oscilloscope to generate licences.
Copy the files with the individual licences to a USB pen drive and install them on scope.
slodat:
Thank you for the file. Looks like it's my web browser was causing me problems. I've generated the *.lis files and the scope says the license isn't the right version. hmm.. My GDS-1054B is v1.23. I get the same error on all of the .lis files. I double checked my serial number.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version