Products > Test Equipment

Power Adapter for DE-5000

<< < (3/6) > >>

David Hess:
I am having the same problem looking for a better fitting plug.  The one I have is barely long enough and some are shorter.

graybeard:
I was lucky enough to find a power connector that worked in my junk parts collection.  It was part of an long dead universal power adapter kit.  I saved this and two other connector from that kit. 

It is just long enough to work with the DE5000.  However a 12mm long one would surely work better.  The plug in my universal adapter set I got from Amazon last year is too short.

The main thing I like about using an external power supply is it disables the automatic power off (APO).

I put an 11V Zener diode (from a bag of misc Zeners in my stock) across the dual banana plugs to protect against stupid operator error.













Chris

David Hess:

--- Quote from: rvalente on May 28, 2021, 12:20:17 pm ---I'd not use this USB to 9V thing, this is probably very poor quality with plenty of noise (just like boost converters usually are)
--- End quote ---

That is my concern and why I inquired about it here.  I could design a fault proof USB to 9 volt converter but consumer stuff is notoriously cheap.

LeonR:
wouldn't be easier to get (or make) a power extension cord?

https://www.amazon.com/Extension-Cords/b?ie=UTF8&node=495312

David Hess:

--- Quote from: LeonR on June 04, 2021, 06:02:56 pm ---wouldn't be easier to get (or make) a power extension cord?

https://www.amazon.com/Extension-Cords/b?ie=UTF8&node=495312
--- End quote ---

I could, but a smaller and thinner power cord in the form of a USB cable would have advantages.  Even an existing AC to USB brick and then USB to 9 volt cable would be less encumbering.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod