Products > Test Equipment

Power supply ripe for the picking

<< < (4/9) > >>

Max3D:
Hi Miq and others,

I found the original software and I can communicate in both directions with the Hammatek / Rockseed / eTommens (the latter being the real manufacturer I believe). I can see the real time status and change voltage or amp settings.
However I have no idea how to set data points comparable to the memory buttons. The interface is there, but I can't see a way to set them. Anyone an idea?

This is the Chinese version with data points on the bottom half. I have exactly the same interface but no idea how to populate the bottom half at the left

tv84:

--- Quote from: Max3D on December 29, 2020, 08:22:55 pm ---This is the Chinese version with data points on the bottom half. I have exactly the same interface but no idea how to populate the bottom half at the left

--- End quote ---

Looking a bit at those curve graphs, it seems that thing is a DMC DeLorean...   ::)

Max3D:
Yeah, so far I didn't manage to get the settings to go back in time ;)

In reality the right hand side are a scrolling view of voltage/Amps over (sequential!) time.

the setting in the lower empty box are Model / Voltage / Current / Power / Duration (ms) / Inaccuracy  / GapOfAdjustments (ms) / Enable

I would love to be able to set these

SpeedProg:
I belive the stuff in the bottom half, I was able to set in one of the config xml files in the programs folder.
Sorry I can't give you any more details, sadly I managed to lose my mini cd and seemed to have deleted the windows vm with the program too, that I used to do research for the rigrok driver.

For those who can compile their own stuff and want to use the HM310P, RS310P with sigrok the driver pull request is here:
https://github.com/sigrokproject/libsigrok/pull/100
for adding HM305P or 60V versions I would still the info to add it to drivers.

I did the pullrequest some time ago, but as it seems it will probably take some months for anything to happen.

trcm:
I modified the https://github.com/markrages/py_test_interface code to report the Class and Model of my HM305P :

--- Code: ---$ ./hm305.py
Class (0x04): 19280
Model (0x03): 305
1.8 Volts
0.0 Amps
0.0 Watts
--- End code ---

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod