Products > Test Equipment

Probe holders

<< < (4/4)

Sighound36:

--- Quote from: hpw on May 21, 2023, 07:58:08 am ---
I mean the much older probes as on picture...

--- End quote ---

Hello Hpw

ZS probes are no problem with these holders see images below I have a fair few of these ZS series and even the 4000 is well held with no damage in the last four years. Also a ZS2500 and a DL-10 HCM can be seen in the image.

The other probes you mentioned sorry I do not have so I can't comment. Though the ZS4000 body is biggest I would suggest you would wish to use with the probe holder as it is.


bookaboo:
I really like both the PCB holder and the probe holder here https://sensepeek.com/

Jeroen3:
I made my own with some aliexpress gooseneck, clothespin and a 3D printed box filled with cement.  :-/O

STL

Gixy:
I use those, expensive but of high quality.
https://sensepeek.com/

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod