Products > Test Equipment

Purchased Rigol DHO-914s

<< < (7/8) > >>

moffy:
I found an english version on their website but you need to register first: https://www.rigol.eu/En/Index/listView/catid/27/tp/4/wd/

TurboTom:
I copied the CN language programming manual to easyupload (valid for one week): https://easyupload.io/vkletl There doesn't seem to be an EN language version of this file available yet.

You'll find the section relevant for programming the AWG starting from page 260. Despite the language, the usage of the SCPI commands should be easily comprehensible.

P.S: Did they really get that wrong in the commands: :SOURce:FUNCtion:SQUare:DUYT instead of :SOURce:FUNCtion:SQUare:DUTY ? Or is it just a typo in the manual?? I re-checked against the DG800/900/200 programming manual. There, the corresponding instruction is: [:SOURce[<n>]]:FUNCtion:SQUare:DCYCle So it's not even consistent throughout Rigol's own gear!  :palm:

moffy:
The english version I downloaded has the same typo?

"3.25.6 :SOURce:FUNCtion:SQUare:DUYT
Syntax
:SOURce:FUNCtion:SQUare:DUYT < percent >
:SOURce:FUNCtion:SQUare:DUYT?
Description
Sets or queries the duty cycle of the square wave generated by the AFG function."

tv84:
Remember that many times Rigol uses their own "english". So, only looking inside the app code one can be sure in those cases.

moffy:
I guess it comes down to try it and see which spelling works. ;)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod