Products > Test Equipment
Q: Front protective cover for HP 16702b logic analyzer?
(1/1)
dorkshoei:
Does any kind of cover exist that covers the LCD and controls on a 16702?     Has anyone made something?

I can see that Tek made one for the TDS3000:  https://www.eevblog.com/forum/buysellwanted/fs-tek-tds3000-front-cover/

I just picked up a mint condition one and I'd like something that will protect the front from damage when the unit is not in use.

Thanks
Halberd:
Hello.

There should have been no front panel cover, at least not a genuine vendor front panel cover, on these series of LAs and DSOs from HP/Agilent.
This is in contrast to those from Tektronix of the same era, which usually had front covers.

We packed a lot of measuring equipment during an office move and had a hard time with equipment that didn't have covers.
dorkshoei:
Thanks.

Searching I couldn't see an official HP part or anything aftermarket.

I posted the TEK link so people would know what I was referring to.

From the  picture the TEK looks to be formed out of that thin foam type material.

I suspect I'm going to need to modify something or make my own.  A similar materia to the TEK implies to me a mould which is more work than I fancy.

Appreciate any thoughts/advice.
dorkshoei:
I'll probably just make one out of acrylic sheet.  Glue or weld seams.  Line with foam to get a snug non marring fit.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod