Products > Test Equipment
Questions about Siglent SDS1202X-E's SCPI interface
<< < (3/4) > >>
tautech:

--- Quote from: tonycstech on October 06, 2023, 03:29:00 am ---wow that was a lot of garbage to download.
System changes, several services added to windows startup WOW and on top of that, refresh rate for the scope wave is pathetic at best.
I guess i need a brand change

--- End quote ---
Good, you have it working then.  :clap:

The thread opened with needing SCPI advice, have you got that working to your needs.
As for refresh rates, nothing beats the webserver that was added later into the 4ch X-E's but not to SDS1202X-E.  :(
Much easier to use too and offers more and better features without any need for those darn drivers.
tonycstech:
Very good.
My computer was bricked. I was unable to load Windows after reboot.
Startup repair did not help.
I have no idea what files i had lost on my desktop thanks to that software.
Good thing i have a flash drive with windows 10 so i was able to reinstall it from a scratch.
Good times.


Oh wait, not i gotta fix windows 10 installing a bootloader to another drive other than its own.
Gotta wipe the system again, this time with other SSD's disconnected during installation.

What a wonderful day.
tautech:
From where did you source the NIVISA package you installed ?
Maybe it was from a dodgy host ?
tonycstech:
https://www.ni.com/en/support/downloads/drivers/download.ni-visa.html#484351
tautech:
 :-//
I've had EasyScopeX on several machines over 10 years, W7, 8 and 10. i3, i5 and i7, all 64 bit but always with just the Runtime driver package, not the full NIVISA install.
On this box are EasyScopeX, EasyWaveX, EasySDL and EasyPower.

Did you study the Easy***** install instructions, attached.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod