Products > Test Equipment
RD6018 on a lower current supply - can I set an OCP current curve?
(1/1)
SpottedDick:
Hi All,

So I'm currently putting together a power supply using a RD6018 and Meanwell 400W 48V 8.3A supply.

(Figures below are just for demonstration)

While at 48V, I'll only get 8.3A, at 24V, I could get 16A.

Is it possible to set an OCP curve for this setup on the RD6018?

Thanks in advance :)
SpottedDick:
Well apparently it's not possible on the default Riden software BUT the Unisoft software adds over power protection, which will do exactly what I want :)
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod