Products > Test Equipment
reading Keysight 3458A serial number
analogRF:
I have a 3458A with the S/N sticker missing.
The firmware revision is 9.2
Is there any way I can read the serial number of the instrument?
ID? only says HP3458A and obviously it does not understand SCPI language :-//
Roehrenonkel:
Hi analogRF,
...try "*IDN?"
Good luck
analogRF:
--- Quote from: Roehrenonkel on April 18, 2024, 01:52:15 pm ---Hi analogRF,
...try "*IDN?"
Good luck
--- End quote ---
like I said this instrument does not understand SCPI commands
egonotto:
Hello,
perhaps the EEVblog Metrology-Forum is a better place for this question.
Best regards
egonotto
coromonadalix:
--- Quote from: analogRF on April 18, 2024, 01:55:47 pm ---
--- Quote from: Roehrenonkel on April 18, 2024, 01:52:15 pm ---Hi analogRF,
...try "*IDN?"
Good luck
--- End quote ---
like I said this instrument does not understand SCPI commands
--- End quote ---
same toughts
the keysight manual specify ID? and not IDN? for a id request, and it report only the model nothing more it seems,
It was asked in another thread here in the past
no SN sticker sound suspicious, these stickers don't remove themselves or fall off easily ?? is it an Fleabay purchase ?
Navigation
[0] Message Index
[#] Next page
Go to full version