Products > Test Equipment
Recapping Tektronix 7904, 7844 etc. power supply
(1/1)
Gianni:
Dear friends,
I ask your help for the power supply of my 7844 (that is almost identical to 7904 and others). I arrived to it for a problem in the readout, with characters that dances in a strange way, but that is not the point.
The problem for which I am asking your help is the recapping of the power supply, that I am investigating because its ripple value is definitely not good. The table below shows the values (in mV) I measured with a 7A22 differential vertical amplifier.

The question is: did anyone recapped a power supply like that? I dismounted the power supply and:

* I am not going to replace the two large 900uF capacitors because they seem to have maintained their value (I measured about 1300uF for both);
* I am going to replace all the other electrolytic capacitors in the rectifier board.What is your opinion about all that above?

Thanks
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod